Adding support for ESP32 boards

This is basically from the github instructions, I have been looking at the ESP32 module

My ESP Arduino installation is located at J:\esp on my PC but other than changing the paths everything went as planned. The board I bought was a Lolin32 from Wemos – we’ll come to that later

 

Tested on 64 bit Windows 10 machine (I don’t have 32 Bit)

  1. Download and install the latest Arduino IDE Windows Installer from arduino.cc
  2. Download and install Git from git-scm.com
  3. Start Git GUI and run through the following steps:
    • Select Clone Existing RepositoryStep 1
    • Select source and destination
      • Source Location: https://github.com/espressif/arduino-esp32.git
      • Target Directory: C:/Users/[YOUR_USER_NAME]/Documents/Arduino/hardware/espressif/esp32
      • Change this to your Sketchbook Location if you have a different directory listed underneath the “Sketchbook location” in Arduino preferences.
      • Click Clone to start cloning the repositoryStep 2 Step 3
    • Open C:/Users/[YOUR_USER_NAME]/Documents/Arduino/hardware/espressif/esp32/tools and double-click get.exeStep 4
    • When get.exe finishes, you should see the following files in the directoryStep 5
  4. Plug your ESP32 board and wait for the drivers to install (or install manually any that might be required)
  5. Start Arduino IDE
  6. Select your board in Tools > Board menu
  7. Select the COM port that the board is attached to
  8. Compile and upload (You might need to hold the boot button while uploading)Arduino IDE Example

How to update to the latest code

  1. Start Git GUI and you should see the repository under Open Recent Repository. Click on it!Update Step 1
  2. From menu Remote select Fetch from > originUpdate Step 2
  3. Wait for git to pull any changes and close Git GUI
  4. Open C:/Users/[YOUR_USER_NAME]/Documents/Arduino/hardware/espressif/esp32/tools and double-click get.exeStep 4

RELATED ARTICLESMORE FROM AUTHOR